Albānija
Amerikas Savienotās Valstis
Argentīna
Austrija
Austrālija
Beļģija
Bosnija un Hercegovina
Brazīlija
Bulgārija
Dienvidāfrika
Dānija
Filipīnas
France
Grieķija
Horvātija
Igaunija
Itālija
Jaunzēlande
Kanāda
Kolumbija
Latvija
Lielbritānija
Lietuva
Luksemburga
Meksika
Melnkalne
Moldova
Norvēģija
Nīderlande
Polija
Portugāle
Rumānija
Serbija
Slovākija
Slovēnija
Somija
Spānija
Turcija
Ukraina
Ungārija
Vācija
Ziemeļmaķedonija
Zviedrija
Čehija
Čīle
Īrija
Šveice
MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit Ģitāras instruments
Zīmols: MusicNomad
Produkta kods: 1313174
Zīmols: MusicNomad
Produkta kods: 1313174
MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit Ģitāras instruments
The MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit gives Gibson and USA-built PRS owners everything needed to dial in neck relief at home. The bundle pairs a precision stainless steel feeler gauge with a 5/16-inch carbon steel truss rod wrench and a clever pick-style capo.
- Three common relief measurements (.006", .008", .010") printed on the gauge handle for electric, acoustic, classical, and bass guitars.
- Pick Capo holds the string at the first fret without bulky clamp tension, allowing for accurate and consistent readings.
- 5/16" wrench with magnetic Phillips screwdriver tip removes tiny truss rod cover screws without dropping them
- Ergonomic rubber handle and protective headstock bumper keep the finish safe during adjustments
Measure and Adjust Neck Relief on Gibson and PRS Guitars
The MusicNomad MN611 Truss Rod Neck Relief Measure and Adjust Kit bundles the two tools needed for a proper truss rod setup. A precision stainless steel gauge offers the three most common neck relief measurements (.006", .008", .010") with instructions printed directly on the handle. Included in the set is a pick-style capo that holds the low E, A, and D strings at the first fret without the bulk of a regular capo, giving a clean reading at the sixth fret.
Premium Wrench Built for the Headstock
This 5/16-inch truss rod wrench is built from carbon steel and sized specifically for Gibson and USA-made PRS guitars. A magnetic Phillips screwdriver on the opposite end lifts the tiny truss rod cover screws safely, while the ergonomic rubber handle and protective bumper prevent scratches on the headstock finish.
Dokumenti
Drošības instrukcijas
Lūdzu, skati šī produkta īpašos drošības norādījumus lietotāja rokasgrāmatā.
